Special Aircraft Service

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Catapult gear and chocks not appearing in BAT  (Read 532 times)

0 Members and 1 Guest are viewing this topic.

Peter Lynn

  • member
  • Online Online
  • Posts: 329
Catapult gear and chocks not appearing in BAT
« on: March 11, 2017, 12:19:02 AM »

I have been trying with no success to persuade chocks and catapult gear to show on screen in BAT WAW. I have checked the PAL entries in Config. and the settings are on 1 and confess I am stumped. Am I missing something in the install? Everything else works splendidly. Can anyone assist please?

Many thanks :)
Logged

SAS~Storebror

  • Editor
  • member
  • Offline Offline
  • Posts: 18333
  • Failure is not an option.
    • What goes around comes around, you'll see
Re: Catapult gear and chocks not appearing in BAT...
« Reply #1 on: March 11, 2017, 12:24:15 AM »

Either you have failed to delete the old Engine Mod folder (that's what my bet is on, it's been clearly stated in the installation instructions but reading and following them apparently and unfortunately is a common issue these days...), or you have installed some other Engine Mod version in parallel (god knows...) or your conf.ini entries are wrong (you could show us so we can check).
In any case, when you do it right, the chocks and cat gears show up fine.

Best regards - Mike
Logged
You've got no one to follow, and no one will follow you. Ain't that a relief?

Peter Lynn

  • member
  • Online Online
  • Posts: 329
Re: Catapult gear and chocks not appearing in BAT...
« Reply #2 on: March 11, 2017, 07:37:59 AM »

Thank you for your assistance Storebror. I have fixed the problem- I had made a silly one line error in the relevant chocks lines in Config.... Repeated the line [Mods] where I should not have.....Works fine now.

Best regards back.....:)
Logged

SAS~Skylla

  • SAS Team
  • member
  • Offline Offline
  • Posts: 1646
  • Flying Ass Clown N°24
Re: Catapult gear and chocks not appearing in BAT
« Reply #3 on: March 11, 2017, 08:41:51 AM »

marked as solved ;)
Logged
When all else fails: read the instructions!
Pages: [1]   Go Up
 

Page created in 0.014 seconds with 26 queries.