Special Aircraft Service

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Roadbuilder/HeightAdaptor updated  (Read 203 times)

0 Members and 1 Guest are viewing this topic.

Nowekat

  • Modder
  • member
  • Offline Offline
  • Posts: 111
Roadbuilder/HeightAdaptor updated
« on: April 05, 2019, 10:47:45 AM »

I fixed a little flaw at the roadbuilder that caused curves to "overshoot" sometimes as the last road plate sometimes rotated a little bit to much.

The HeightAdaptor also handels now a filltilesize of only 2 when flatting the road area. This is much smaller then the size of 3 used before, but may be to small when using parallel running rails sometimes. For this you can select this in the HeightAdaptor.ini
Also negative values work now with the general shift.
At least i added a function that leaves all heights of 0 meter unchanged if a further parameter in the HeightAdaptor.ini is set to "1". This helps with roads running to bridges or roads near along rivers and the shore.

The downloadlink remains the same:

https://www.mediafire.com/file/gt7f68c1dsgpooo/RoadBuilderV1.2.7z/file

Nowekat
Logged
Pages: [1]   Go Up
 

Page created in 0.012 seconds with 25 queries.